Archive for March, 2012

10 Simple And Proven Ways To Save Fuel .

Wednesday, March 14th, 2012

'At the heaviest American suv, you can easily save a good half of the fuel tank "- says the American automotive expert Aaron Gold, which offers 10 simple and proven methods save fuel. If you try them, in fact, experts say, then very soon notice that at least began to stop off for refueling. Certainly, the use of each board individually large effect will not, therefore, approach to a complex economy. First you need to check the air filter on the pressure in the tires depends on many things slowly, drive safely – then you will ride for dalnoboy-schikom reduce fuel consumption if you decide to save, the first thing to do is check the air filter. A dirty air filter restricts the flow of air into the engine, which adversely affects his work, and thus on fuel consumption. Check and replace the air filter case pair Minutes: remove it and lift up to the light – if light does not pass, the filter should be replaced. Also, in order to save should be used for engine "light" motor oils with low viscosity, based on synthetic or common factor, which directly affects fuel consumption and drivers who ignore it.

Should check the pressure in the cold tires, since the motion heats the tires and increases the pressure. In some cases, you can need to go slower, and this is the third board. Slow and steady wins – race. Try just for the sake of experiment, ride a couple of days, not exceeding a certain speed.

The Workplace

Sunday, March 11th, 2012

As for indoor unit, it is set to special bracket that is attached with screws to the wall (if the block wall) or ceiling (if the ceiling). After installation, you must test the strength of attachment. The design should not wobble and vibrate when you turn conditioner. For the floor block special fastening is required. When choosing a location, keep in mind that the muzzle of the air conditioner is not on the curtains or wall, and that he was standing away from the heat source.

After laying all communications unit to move from place to place anymore. Places, not suitable for the installation of the indoor unit: on any heat source. Otherwise the air conditioner will run constantly to cool at full capacity and fast fails, in areas where devices are constantly working with high-frequency electromagnetic waves (eg, drill, drill press). High-frequency oscillations can knock the setting of the processor, installed inside the air conditioner; over the bed or the workplace to prevent colds, and in areas where air circulation is impeded, such as behind curtains. The distance to the obstacle should be at least 3 meters. Otherwise air conditioner, which automatically maintains a preset temperature, it will fail. Cooled (or heated) air flow from the air conditioner will be reflected from the obstacle and come back with the same temperature, with what came out of the apparatus. Setting the air conditioner will show that the right climate is installed and the unit turned off, when you install the indoor unit should not be upright.

Otherwise it from the floor will follow the water (condensate), which according to the rules assembly should be given to the drainage tube in a special tank.